Use and Care Manual

• Remove the battery pack from the product when not

in operation.

• Keep the battery pack away from paper clips, keys,

nails, screws, or other small metal objects while in

operation. This can make a connection between

terminals. Shorting the battery pack terminals

together can cause burns or a fire.

ASSEMBLY

WARNING: Read the safety chapter before

you assemble the product.

To assemble the blower tubes

Note: Apply water-based lubricant on the end of the

tubes to make assembly easier.

1. Loosen the screw on the tube clamp with a

screwdriver.

2. Attach the top tube with the digital control handle to

the flexible tube.

3. Tighten the screw on the tube clamp with a

screwdriver.

4. Attach the control wire to the clips on the tube

clamps.

5. Attach the middle tube to the top tube until the tab

goes into the hole. Make sure the tubes are locked

together.

6. Attach the nozzle to the front tube until the tab goes

into the hole. Make sure the tubes are locked

together.

To adjust the digital control handle

1. Turn the knob below the digital control handle

counterclockwise to loosen.

2. Adjust the digital control handle to the necessary

operation position.

3. Turn the knob clockwise to tighten.

To change the product to left-handed

operation

Note: Do not cause damage to the wires below the

covers. Damaged wires can cause the product to not

operate correctly.

1. Use a screwdriver to remove the screws on the rear

cover and lower cover.

2. Remove the rear cover and lower cover to access

the fan housing assembly.

369 - 002 - 17.11.2017