Lawn Mower User Manual

ManualsBrandsPoulan Pro ManualsLawn MowerPDGT26H48B

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.

To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use

the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard

wrench sizes are listed.

(1) Pliers (1) Tire pressure gauge

(2) 9/16" wrench (1) Utility knife

(1) 1/2" wrench (1) 3/4" socket w/drive ratchet

When right or left hand is mentioned in this manual, it means

when you are in the operating position (seated behind the

steering wheel).

TO REMOVE TRACTOR FROM

CARTON

UNPACK CARTON

• Remove all accessible loose parts and parts cartons

from carton.

• Cut along dotted lines on all four panels of carton.

Remove end panels and lay side panels flat.

• Remove mower and packing materials.

• Check for any additional loose parts or cartons and

remove.

BEFORE REMOVING TRACTOR FROM

SKID

_ STEERING

@1 w

INSERT

_ HEX BOLT

(_.,., _ LOCK WASHER

_ LARGE FLAT

SHER

STEERING \ _k. J "_ // STEERING

WHEEL \_'_-__ / i _// WHEEL

STEERING _ ADAPTOR

SLEEVE EX---......___ TABSTENTION

STEERING

SHAFT

STEERING

SLEEVE

FIG. 1

ATTACH STEERING WHEEL (See Fig. 1)

• Remove hex bolt, lock washer and large flat washer

from steering shaft.

• Position front wheels of the tractor sothey are pointing

straight forward.

• Slide the steering sleeve over the steering shaft.

• Align tabs and press steering sleeve extension into

bottom of steering wheel.

• Position steering wheel so cross bars are horizontal

(left to right) and slide onto steering wheel adapter.

• Secure steering wheel to steering shaft with hex bolt,

lock washer and large flatwasher previously removed.

Tighten securely.

• Snap steering wheel insert into center of steering

wheel.

• Remove protective materials from tractor hood and

grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN

SKID THAT MAYPUNCTURE TIRES WHERE TRACTORIS TO

ROLL OFF SKID.

HOW TO SET UP YOUR TRACTOR

CHECK BA'n'ERY (See Fig. 2)

• Lift hood to raised position.

• If this battery is put into service after month and year

indicated on label (label located between terminals)

charge battery for minimumof one hour at 6-10 amps.

(See"BATIERY" inMaintenance section ofthismanual

for charging instructions).

/ t"

!£.

LABEL

FIG. 2