Use And Care Manual

LED screen Possible faults Possible steps
LED 1 is red and LED 2 is
green, battery pack does not
charge or operate correctly in
product
Battery pack failure Remove battery pack from the product. Do not charge.
Battery pack is damaged and must be replaced. Speak to
an approved service center.
RED LED comes on, LED 2
is green and flashes during
charging or when the battery
pack is in the battery charger
Internal battery tempa-
ture is too low or too
high for charging
Move the battery charger and battery pack to a location
where the internal temperature of the battery pack can be
between 5°C (41°F) and 45°C (113°F).
RED LED flashes and LED 2
flashes green when the bat-
tery pack is installed.
Internal battery tempera-
ture is too low or too
high
The internal temperature in the battery must be between
-15°C (5°F) and 70°C (158°F). The environment tempera-
ture in the battery pack is too low or too high.
•
If the battery pack is too cold from the ambient envi-
ronment, move the battery pack and battery charger to
a warm environment.
•
If the battery pack is too hot, especially after operation,
move the battery pack and battery charger away from
the hot environment.
TECHNICAL DATA
unit PRHT22i (BHT58VPR)
Motor specifications
Motor type Brushless
Motor voltage V (DC) 58
Motor power W 500
Battery and charger specifications
Default battery pack type PR140Li
Default battery charger type PR275Ci
Blade specifications
Blade speed (standard / boost) min
1
1400 / 1900
Blade length cm (in) 55 (21.6)
Cutting capacity mm (in) 19 (0.75)
Product dimensions
Weight (without battery) kg (lb) 3.66 (8.1)
398 - 002 - 20.11.2017 9