Owner's Manual
7
ASSEMBLY
WARNING: Before using chain
saw, ensure all fasteners are sec ure.
CARTON CONTENTS
S Chain Saw (ful l y assembled)
S Bar Sheath
Examine part s for damage. Do not use
damaged parts.
NOTE: If you need assista nce or find t hat
parts are missing or damaged, please call
1-800-554- 6723.
ASSEMBLY
Your unit is fully assembled; no assembly
is required.
OPERATION
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR
CHAIN SAW.
Compare the illustrations with your unit to familiarize yourself with the loca-
tion of the various controls and adjustment s. Save this manual for futur e reference.
Bar Oil Cap
Trigger
Switch
Power
Cord
Chain
Bar
Trigger Lockout
Button
Handguard
Bar
Clamp
Chain
Adjusting Wheel
Bar Knob
TRIGGER SWITCH
The
TRIGGER SWITCH is used to turn on
the unit. Squeeze the trigger switch to
operate the unit after lock--out button
has been push ed forward. Release the
trigger to turn the unit off.
TRIGGER LOCK--OUT BUTTON
The
TRIGGER LOCK--OUT BUTTON is a
control feature designed to prevent the
motor from being accidently started.
When the rear handle is gripped in a nor-
mal cutting position, the lock--out button
can be pus hed in by the thumb, permit-
ting the index finger to squeeze the trig-
ger. It is not necessa ry to maintain pres-
sure on the lock--out button once the
trigger has been engaged.
BAR OIL CAP
The
BAR OIL CAP is used to fill the bar oil
tank.
CHAIN ADJUSTING WHEEL
The
CHAIN ADJUSTMENT WHEEL is us ed
to adjust the chain tension.
POWER CORD
The
POWER CORD is used to connect
the chain saw to an approved extension
cord.
CHAIN TENSION
It is normal for a new chain to stretch dur-
ing fi r st 15 minutes of operation. You
should check your chain tension fr equent-
ly. See
CHAIN TENSION under t he SER-
VICE AND ADJUST M ENT S
section.
OPERA TING INSTRUCTIONS
Use only a voltage supply as specif i ed on
your unit.
SELECT AN EXTENSION CORD
MINIMUM WIRE GAUGE
RECOMMENDATIONS
Volts
120
14
A.W.G.*
*American Wire Gauge
25 ft.
(7.67 m)
12
A.W.G.*
50 ft.
(15.24 m)
100 ft.
(30.48 m)
NOT
RECOMMENDED
ATTACH THE EXTENSION CORD TO
YOUR CHAIN SAW
To prevent disconnection fr om unit, se-
cure extension cord to power cord as
shown in the following illustration.
Power Cord
Extension Cord