PRO Chain Saw Instruction Manual

8
Chain Brake
Nuts
WARNING: If the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious injury.
OPERATION
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR
CHAIN SAW . Compare the illustrations with your unit to familiarize yourself with the location of the
various controls and adjustments. Save this manual for future reference.
Chain Adjustment Tool
(Bar Tool)
Front Handle
Front Hand Guard
Chain
Bar Oil
Fill Cap
Starter Rope
ON/STOP
Switch
Starter Housing
Fuel Mix Fill Cap
Muffler
Bar Sprocket
Hole
Bumper
Spike
Direction
of Chain
Travel
Guide Bar
Chain Brake Nuts
Chain Brake
Choke
/
Fast Idle
L
e
v
er
Throttle
Trigger
Rear
Handle
Cylinder Cover
Throttle
Lock--out
Adjusting
Screw
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
T H R O T T L E L O C K --- O U T
The THROTTLE LOCK--OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the trigger.
CHOKE/FAST IDLE LEVER
The choke and fast idle speed are set by pull-
ing the CHOKE/FAST IDLE LEVER out fully
for cold or for refueled starting. The choke
provides additional fuel to the engine during
cold starting.
CHAIN BRAKE
The CHAIN BRAKE is a device designed to
stop the chain if kickback occurs. The chain
brake activates automatically in the event of
kickback. The chain brake activates manu-
ally if the front hand guard is pushed forward.
The chain brake is disengaged by pulling the
front hand guard back toward the front han-
dle as far as possible.
CHAIN TENSION
It is normal for a new chain to stretch during first
30 minutes of operation. You should check
your chain tension frequently. See CHAIN
TENSION in the ASSEMBL Y section.
WARNING: Muffler is very hot dur-
ing and after use. Do not touch the muf fler or
allow combustible material such as dry
grass or fuel to do so.