PDR-654/PDR-654T 6.5” Monitor MP3/MP4 Player AM/FM Radio Built-in TV tuner (only for PDR-654T model) Owner’s Manual Take the time to read through this owner’s manual. Familiarity with installation and operation procedures will help you obtain the best Performance from your new device.
Important Safeguards z Using the device at temperature below -10℃ may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! z Read carefully through this manual to familiarize you with this high-quality sound system. z Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. z When replacing the fuse, be sure to use one with an identical amperage rating.
Contents Important Safeguards................................................................................................................... 2 Contents....................................................................................................................................... 3 Accessories.................................................................................................................................. 4 Installation/Un-installation ..............................................
Accessories Package contains the following accessories for installation and operation of the unit.
Installation/Un-installation Note Before starting installation of the unit, make sure the wiring is connected properly. Use only the parts provided with the unit to ensure proper installation. The use of unauthorized parts may cause malfunction. Install the unit where it does not get in the driver’s way and will not injure the passenger in case there is a sudden stop, like an emergency stop.
Wiring Connections NOTE: Never connect cable to the system while it is connected to the battery power. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. Note: To watch video the parking wire should be connected to break signal. 2 cables is connected to a Hands-Free device (not included).
Note: - Only use groundless loudspeakers. - Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loudspeakers at higher volumes. - Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. - Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body (GND). The unit is using a BTL circuit and each loudspeaker must be connected with insulated cables according the diagram.
Panel Control 1. POWER/MUTE Button Press it to turn on the unit. When turned on, press it to mute the volume output, press and hold for 2 seconds to turn the unit off when the unit is on. (* Press any button on panel to turn on the unit) 2. VOL Knob Adjust the volume level by turning the knob clockwise to increase or counterclockwise to decrease. 3.
Remote control 1: MENU 2: POWER 3: UP 4: BAND/M.SEL/RDM 5: ENTER 6: LEFT/SEEK-/FAST BACKWARD 7: DOWN 8: REPEAT/INT 9: AS/PS 10: MODE 11: DIGIT NUMBER 12:PLAY/PAUSE 13:MUTE 14: AUDIO 15: SUBTITLE 16:RIGHT/SEEK+/FAST FORWARD 17:VOLUME PLUS 18:SET 19: VOLUME MINUS 20: EQ/LOUD 21: SEL 22: SCALE/ROTATE 23: GO TO Remove Battery Note: The distance may vary according to the brightness of ambient light.
Main Menu The best way to discover the program is to explore each screen in detail, and to find out how to move from one to another. Read this chapter for a guided tour. Unit starts by displaying the Main menu. This is the root of the screen hierarchy, and you can simply access all features by tapping on the touch screen buttons. Tap the icons to enter a desired mode. ◆Radio Player To start Radio, tap RADIO button on main menu screen, or press the MODE button on the front panel or RC repeatedly.
◆USB/SD/MMC Interface / To start USB /SD /MMC, tap the corresponding icon on main menu screen, or press the MODE button on the front panel or RC repeatedly. Touch it to turn to previous content Touch it to select music document folder Touch it to select photo document folder Touch it to select video document folder Touch it to pause the playback, touch again to resume.
◆TV Model (only for PDR-654T) To start TV mode, tap on TV button from main menu screen. Connect a TV antenna to the TV antenna jack of the unit. Select TV mode; press on the center of the touch screen, and following interface will be display: 1. In TV mode, press the play/ pause button on the RC to enter TV menu setting, or press touch-screen to choose TV MENU icon to enter TV MENU. 2. Press the / on remote or tap the screen to select one of the setup pages: Auto program => Manual program. 3.
z System Select this menu item is to set TV system: SECAM => NTSC =>PAL, press NTER button on the remote or tap the screen to select. z Audio Select this menu item is to set the TV sound system: When system setting PAL, press ENTER on remote or tap the screen button to select TV sound system: D/K=>M/N=> B/G=> I. When system setting SECAM, TV sound system B/G=>I=>D/K. When system setting NTSC, press button to automatic skip TV channel term.
LONDNESS: Selecting loudness ON will emphasize the low frequency output. BEEP: Keypad sound setting. Display Bright: set the LCD screen brightness up or down Contrast: set contrast up or down Saturation: set saturation up or down General Clock hour: select 12-hour or 24-hour clock display mode. Clock set: Press number buttons to input the current time. Radio Area: Select radio broadcasting area. Stereo: Select stereo on or off.
CALIBRATION procedure of the touch screen is described as below: When the target moves to another position, tap and hold at the center of the new target. Repeat each time to complete the calibration process. When the calibration has been completed, the device switches back to the previous operating mode and retain the previous setting. If you press Reset button, the setting will return to factory setting.
Troubleshooting guide Symptom Cause Solution General No power The car ignition is not on. The fuse is blown. If the power supply is properly connected to the car accessory switch the ignition key to “ACC”. Replace the fuse. No sound Volume is in minimum. Wiring is not properly connected. Adjust volume to a desired level. Check wiring connection. The operation keys do not work. The radio does not work; the radio station automatic selection does not work.
Specification General Power supply: Current consumption: Maximum power output: 12 V DC Max. 10 A 35W x 4 channels (Max.) Compatible formats: MP3/MP4/WMA/ JPEG/RMVB Dimensions (W x D x H) / 178 x 165 x 100 mm / 1.6 kg weight: Working temperature -10℃ - +60℃ range: TFT display Screen size: 6.5 inch Resolution: 400*240 pixel Aspect ratio: 16:9 Contrast ratio: 500:1 Brightness: 400 cd/㎡ View Angle 70° FM Stereo Radio Frequency range(U.S.A AREA) 87.5 – 107.9MHz(Step 200KHz) Frequency range(EUROPE AREA): 87.