User's Manual

Enclosure Construction
Enclosure Dimensions
www.PowerAcoustik.com
Included in this manual are a number of different enclosure sugges-
tions. These are by no means the only enclosures to use, but they
provide a starting point to determine the correct enclosure for your
needs many factors must be addressed (amount of power, vehicle,
placement, crossovers, etc) Therefore, as always, SPL recommends
that your subwoofer be installed by an authorized SPL dealer.
All enclosures should be made of .75” (3/4”) material only. When pos-
sible, make the baffle 1.5” (1 ½) thick and add .75” (3/4”) to the depth
of the enclosure to compensate. All volumes INCLUDE vent/port and
subwoofer displacements. DO NOT change the volume unless you
plan on adding a substantial amount of bracing. For added per-
formance, applying a coat of fiberglass resin to the interior walls will
greatly improve sealing the enclosure. Adding a thin layer of poly-fill
will improve response by smoothing out reflections within the enclo-
sure.
seaLed
mInImum .45 cu Ft. .75 cu Ft 1.0 cu Ft
optImum .75 cu Ft. 1.0 cu Ft. 1.25 cu Ft.
p
oRted
mInImum .75 cu Ft. 1.0 cu Ft. 1.5 cu Ft.
p
oRt WxL 4Inch x 7.5Inch 3Inch x 4.5Inch 5Inch x 4.5Inch
F3 hz 63 48 65
optImum 1.0 cu Ft. 1.5 cu Ft. 1.75 cu Ft.
p
oRt WxL 4Inch x 6.35Inch 4Inch x 8.5Inch 5Inch x 4Inch
F3 hz 48 40 50
RW1-8 RW1-10 RW1-12