PTID-3600/ PTID-3600T In-Dash 3.6” Monitor Touch Sensor DVD/CD/MP3/MP4 MW/FM Radio Built-in TV tuner Owner’s Manual Take the time to read through this owner’s manual. Familiarity with installation and operation procedures will help you obtain the best Performance from your new DVD-receiver.
Table of Contents Table of Contents.......................................................................................................................1 Important Safeguards.................................................................................................................2 Accessories .......................................................................................................................3 Installation/Un-Installation ...........................................................
Important Safeguards z Using the device at temperature below -10℃ may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! z Read carefully through this manual to familiarize yourself with this high-quality sound system. z Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. z When replacing the fuse, be sure to use one with an identical amperage rating.
Accessories Package contains the following accessories for installation and operation of the unit.
Installation/Un-Installation First complete the electrical connections, and then check them for correctness. Installation This unit can be installed in any dashboard having an opening as shown on the picture. The dashboard should be 4.75 – 5.56 mm thick in order to be able to support the unit. 1. Insert mounting collar into the dashboard, and bend the mounting tabs out with a screwdriver. Make sure that lock lever(※)is flush with the mounting collar (not projecting outward). 2. Secure the rear of the unit.
Wiring Connections Make sure you have good chassis ground. A good ground connection will eliminate most electrical noise problems. A good chassis ground requires a tight connection to the vehicle’s metal chassis. The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust, or dirt for a good electrical connection. **TV antenna is for PTID-3600T only.
Detachable Control Panel Detaching the control panel z Turn the Power off. z Press OPEN button release the panel. z Pull the panel out. Attaching the control panel z Insert the left side of the control panel into the main unit. z Press the control panel right side until the “click” sound is heard. Caution: DO NOT insert the control panel from the right side. It can damage the control panel. The control panel can easily be damaged by shocks.
Panel Controls Front panel 1. AUX IN 6. VOL + 11. MODE 16. BAND 2. POWER/ MUTE 7. PLAY/PAUSE 12. PREVIOUS 17. USB 18. Memory Card slot 19. EJECT button 20. Disc slot 3. IR sensor 8. MENU 13. VOL 4. AS/PS 9. TFT display 14. OK 21. RESET 22. Flashing LED Page - 7 5. SEL 10. OPEN 15.
IR Remote Control 1. MODE 2. POWER 3. BND/RDM 4. ENTER 5. Cursor / / / 6. STEREO/MONO 7. LOC/ PROG 8. P.SCN/RPT 9. SEEK-/ 10. LOUD 11. OSD 12. STOP/ PBC 13. Digit 0-9 14. 15. MUTE 16. MENU 17. SUB-T 18. SETUP 19. ANGLE 20. INT 21. VOL+ 22. A-B/ZOOM 23. SEL 24. SEEK+/ 25. VOL26. AUDIO/ GOTO REPLACING THE BATTERY Remote Control comes with a CR-2025 Lithium Battery included. 1. Remove the Battery Holder from the back of the Remote Control. 2.
Do not re-charge, short, disassemble or heat the battery or dispose it in fire. Do not expose or bring into contact the battery with other metallic materials. Doing this may cause the battery to give off heat, crack or start a fire.
Audio Setting Press SEL button on the Remote Control to select the audio setting (or on front panel, long press SEL button in radio mode, short press SEL button in other mode to select the audio setting) BASS =>TREBLE => BALANCE => FADER => EQ. Press / buttons on remote to select the audio setting item (or press the VOL knob on front panel to select the setting item). button on remote control or OK button on front panel to enter the Press ENTER button or selected item.
z PICTURE MENU MENU DESCRIPTION RED Adjust level of red color. Support 50 levels. Default level is 25. GREEN Adjust level of green color. Support 50 levels. Default level is 25 BLUE Adjust level of blue color. Support 50 levels. Default level is 25. BRIGHTNESS Adjust level of screen brightness. Support 50 levels. Default level is 25 CONTRAST Adjust level of screen contrast. Support 50 levels. Default level is 25. SHARPNESS Adjust level of screen sharpness. Support 15 levels.
Digital Tuner Note: Memory Card /USB service availability varies with areas. Please understand if Memory Card /USB service is not available in your area, the following service is not available, either. Band selection Press MODE button to select the RADIO mode. Press the BAND button to select the desired band: FM1=> FM2 => FM3 => MW STEREO/MONO In FM mode, press SETREO/MONO button on remote control to select stereo or mono sound reception.
Memory CARD To play MP3/ MP4/ WMA files on a Memory CARD, insert the card into the card slot (you should press the OPEN button on the panel to flip down front panel and insert the card into card slot.) The unit will start playing MP3/ MP4/ WMA files on the Memory card memory automatically. Or press the MODE button to select Memory Card after pressing POWER Button to turn on the unit. PAUSE/ PLAY Press the PLAY/ PAUSE button to pause the playback. Press the button again to resume.
Random Press the RDM button on remote to play all song tracks in random order. Press and hold for two seconds to play all album tracks in random order. Press again to cancel. Note: This function is only for audio files. Intro Playback Press the INT button on remote to play the beginning of every track for 10 seconds in sequence. Press again to cancel INT play. Note: This function is only for audio files. Programming the Playback 1. Press PROG button on the remote open program menu. 2.
Discs operations Glossary PBC (Play Back Control) Play Back Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc.
Loading a disc 1. Turn the power on. 2. Press the Open button on the front panel to flip it down. 3. Insert the disc with the printed side facing upward into the slot. The panel will be closed automatically. The DVD mode will be turned on automatically. The monitor will show the disc content. 4. Press Open button on the panel and Eject button inner the panel to eject the disc. If the disc is not removed for about 10 seconds after reject, the disc will reinserted automatically.
Repeat A-B function 1. During playback, press A-B button on the remote control at the starting point of the section you want to repeat (point A). 2. Press A-B button again at the ending point of the section you want to repeat (point B). Section A-B repeating starts. 3. Press A-B button again to cancel the A-B repeat function. Random playback (for CD/VCD/MP3 discs) During disc playback, press the RDM button on the RC to start random playback of the disc. Press again to cancel.
Changing the subtitle language (for DVD only) Press SUBTITLE button on the RC to select the preferred language for the disc menu. When the selected language is recorded on the disc then this language will automatically be selected. If not, the first language recorded on the disc is displayed. Changing size Press and hold for 2 seconds the A-B/ZOOM on the RC. The picture will be enlarged accordingly: X2 => X3 =>X4 => X1/2=>X1/3=>X1/4X=>Normal.
z You should not write non-MP3 files or unneeded folders along with MP3 files on the disc otherwise it takes a long time until the unit starts to play MP3 files. z With some CD-R or CD-RW media, data may not be properly written depending on its manufacturing quality. In this case, data may not be reproduced correctly. High quality CD-R or CD-RW disc is recommended. z Up to 16 characters are displayed for the name of an Album or a Track. ID3TAG version 1.x is required.
Compatible Files 1. Audio files: MP3, WMA 2. Video files: MPEG4 TM1 3.11, 4X, 5X and 6X versions Nero Digital TM2 Real time MPEG2 MP@ML display Real time MPEG1 D1 (720X480X30/ 720X576X25) decoding Setup Menu • Press SETUP button to enter the system settings main menu; • Press cursor / buttons to move along icons on the top navigation bar on settings main menu.
Commonly used rating codes: Code Description None Kid safe G General Audiences - All ages admitted PG PARENTAL GUIDANCE SUGGESTED - Some material may not be suitable for children PG-13 PARENTS STRONGLY CAUTIONED - Some material may be inappropriate for children under 13 PG-R Restricted, under 17 requires accompanying parent or adult guardian.
Video Setup: Brightness With this menu item you can set up the brightness of the image. Contrast With this menu item you can set up the contrast of the image. Hue With this menu item you can set up the hue. Saturation With this menu item you can set up the color saturation. Sharpness With this menu item you can set up the sharpness of the image. Digital setup Dynamic range This function is to obtain different compression results of the audio signals, default is set to “OFF”.
Note on Discs Only use groundless loudspeakers. Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loud speakers at higher volumes. Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body. (GND). using a BTL circuit and each loudspeaker must be connected with insulated cables according the diagram.
Troubleshooting Guide Symptom Cause Solution General No power The car ignition is not on. The fuse is blown. If the power supply is properly connected to the car accessory switch the ignition key to “ACC”. Replace the fuse. Disc Disc cannot be loaded. Presence of disc inside the player Remove the disc in the player then put a new upward. Inserting the disc in upside down. Compact disc is extremely dirty or defective. Temperature inside the car is too high.
Specification General Power supply: Current consumption: Maximum power output: Compatible formats: Dimensions (W x D x H) / weight: ESP function: Working temperature range: TFT display Screen size: Resolution: Aspect ratio: Contrast ratio: Brightness: FM Stereo Radio Frequency range: Usable sensitivity: Preset memory stations: MW section Frequency range: Preset memory stations: Audio specification Maximum output: Frequency response: S/N ratio(A-vtd): DSP sound effect: Line out Line outs: Video Output 12 V