Replacement Part List

36 in. EXTENSION WAND SYSTEM

AP31EW01

WARNING:

To reduce the risk of injury, user must read and understand the operator’s

manual for their pressure washer before using this accessory. To reduce the

risk of injury or property damage, spray the pressure stream in a safe direction

to ensure proper connection of all accessories before starting any cleaning

project. Fits most pressure washers. Ensure compatibility and proper fit before

using this accessory. Wear eye protection marked to comply with ANSI Z87.1.

Risk of fluid injections; do not point at people, pets, electrical devices or the

unit itself. Turn off the pressure washer, relieve the water pressure in the trig-

ger handle, and lock the lock out on the trigger handle (if one is included with

your pressure washer) before installing, changing, or adjusting accessories.

For cold water use only. For outdoor use only – store indoors. Save these

instructions. Refer to them frequently and use them to instruct other users. If

you loan someone this tool, loan them these instructions also.

This extension wand system is for use with pressure washers up to 4500 PSI.

INSTALLING/REMOVING THE EXTENSION WAND

See Figure 1.

n Place the threaded end of the extension wand (B) in the connector on the end

of your trigger handle (A). Turn the coupler clockwise until it stops to secure

the connector in place.

n Attach the quick connect coupler (C) into the extension wand (B) and check

to make sure it is secured properly.

n Place the threaded end of your spray wand (D) in the connector on the end

of the quick connect coupler (C). Turn the coupler clockwise until it stops to

secure your spray wand in place.

n Unscrew the extension wand from your trigger handle to remove.

Fig. 1

TECHTRONIC INDUSTRIES POWER EQUIPMENT

P.O. Box 1427, Anderson, SC 29622, USA n 1-866-340-3912

Manufactured for the Home Depot Corp., Atlanta, GA 30339 by Techtronic Industries Power Equipment

995000639

8-1-18 (REV:01)

Fits these brands / adapte ces marques / cabe estas marcas de fábrica:

BRUTE, BRIGGS & STRATTON, CAMPBELL HAUSFELD, CRAFTSMAN, DEWALT, EXCELL, HOMELITE, HUSKY, JOHN DEERE, KARCHER, MILWAUKEE, RIDGID,

RYOBI, TASK FORCE, TROY-BILT

The 36 in. wand can also be used to replace your existing spray wand and is

compatible with most 1/4 in. quick-connect accessories and nozzles.

The 36 in. wand can be used between your trigger handle and your existing spray wand to extend them.

PAGE 1
36 in. EXTENSION WAND SYSTEM AP31EW01 A B C D The 36 in. wand can be used between your trigger handle and your existing spray wand to extend them. Fig. 1 This extension wand system is for use with pressure washers up to 4500 PSI. WARNING: To reduce the risk of injury, user must read and understand the operator’s manual for their pressure washer before using this accessory.
PAGE 2
A B C D La rallonge pour lance de 914,4 mm (36 po) peut être utilisée entre votre poignée à gâchette et votre lance de pulvérisation existante pour les rallonger. La varilla de extensión de 914,4 mm (36 pulg.) se puede usar entre el mango del gatillo y la tubo rociador existente para extenderlas. SYSTÈME DE RALLONGE POUR LANCE DE 914,4 mm (36 po) AVERTISSEMENT : Fig. 1 SISTEMA DE VARILLA DE EXTENSIÓN DE 914,4 mm (36 pulg.