Operation Manual

CONTROLS AND FEATURES:
1. LIMIT INDICATOR
This indicator will blink on occasion when the built in limiter is active.
NOTE: If the indicator glows or starts to blink frequently, you should turn down the Subwoofer
Level.
2. SIGNAL INDICATOR
This indicator will glow when there is a signal received to the FULL RANGE input.
3. SUBWOOFER GAIN CONTROL
To regulate the output level of the subwoofer. Use this to set the balance between the speakers
and subwoofers.
4. PROTECT INDICATOR
This indicator will begin to glow when the subwoofer goes into protect mode and all output will
stop. This will prevent the subwoofer amplifiers from getting too hot and will protect all speakers
connected.
5. POWER LED
LED lits when you switch on the power.
6. HIGH PASS XLR OUTPUT
These outputs are used to send the incoming signal to a full range active speaker or power
amplifier.
7. PHASE SWITCH
This switch reverses the polarity of the subwoofer. Experiment (placement of the subwoofer
relative to the speakers) with all speakers to find the best sound.
8. FULL RANGE XLR INPUTS
Are designed to accept a line input signal from a mixer or other line devices with a balanced jack.
Use balanced cables in order to prevent signal loss. ONLY USE LINE LEVEL INPUT DEVICES.
9. THRU (FULL RANGE OUTPUTS)
Are used to send the signal from FULL RANGE INPUTS to another device.
10. TO SATELLITE SPEAKER OUTPUT
Gain controllable outputs to connect passive speakers.
11. SATELLITE SPEAKER GAIN CONTROL
To regulate the output level of the stereo signals.