Datasheet

16
G
4/05
TNY263-268
NOTES:
A. Total current consumption is the sum of I
S1
and I
DSS
when EN/UV pin is shorted to ground (MOSFET not
switching) and the sum of I
S2
and I
DSS
when EN/UV pin is open (MOSFET switching).
B Since the output MOSFET is switching, it is difficult to isolate the switching current from the supply current at the
DRAIN. An alternative is to measure the BYPASS pin current at 6.1 V.
C. BYPASS pin is not intended for sourcing supply current to external circuitry.
D. See Typical Performance Characteristics section for BYPASS pin start-up charging waveform.
E. For current limit at other di/dt values, refer to Figure 25.
F. This parameter is derived from characterization.
G. This parameter is derived from the change in current limit measured at 1X and 4X of the di/dt shown in the I
LIMIT
specification.
H. Breakdown voltage may be checked against minimum BV
DSS
specification by ramping the DRAIN pin voltage up
to but not exceeding minimum BV
DSS
.
I. Auto-restart on time has the same temperature characteristics as the oscillator (inversely proportional to
frequency).