User guide

ManualsBrandsPower Jacks ManualsAccessories for electricalSpiracon™

POWER JACKS LTD DOCUMENT Spiracon

Tel: +44 (0) 1358 285100 ISSUE No 1.4

email: sales@powerjacks.com PAGE

of 4

http://www.powerjacks.com

_________________________________________________________________________________

SPIRACON

INSTALLATION AND MAINTENANCE

POWER JACKS LTD

BALMACASSIE COMMERCIAL PARK

ELLON

ABERDEENSHIRE

AB41 8BX

SCOTLAND (UK)

TEL +44 (0)1358 285100

email: sales@powerjacks.com www.powerjacks.com

Summary of content (4 pages)

PAGE 1
POWER JACKS LTD DOCUMENT Spiracon Tel: +44 (0) 1358 285100 ISSUE No 1.4 email: sales@powerjacks.com PAGE 1 of 4 http://www.powerjacks.com _________________________________________________________________________________ SPIRACON TM INSTALLATION AND MAINTENANCE POWER JACKS LTD BALMACASSIE COMMERCIAL PARK ELLON ABERDEENSHIRE AB41 8BX SCOTLAND (UK) TEL +44 (0)1358 285100 email: sales@powerjacks.com www.powerjacks.
PAGE 2
POWER JACKS LTD DOCUMENT Spiracon Tel: +44 (0) 1358 285100 ISSUE No 1.4 email: sales@powerjacks.com PAGE 2 of 4 http://www.powerjacks.com _________________________________________________________________________________ 1.0 SCOPE. This specification covers the unpacking, handling, operation and maintenance for SPIRACONTM Roller Screws manufactured by Power Jacks. 2.
PAGE 3
POWER JACKS LTD DOCUMENT Spiracon Tel: +44 (0) 1358 285100 ISSUE No 1.4 email: sales@powerjacks.com PAGE 3 of 4 http://www.powerjacks.com _________________________________________________________________________________ When installing the Spiracon roller screw ensure that the alignment of the screw in its support bearings is within 0.1/1000. Once the Spiracon roller screw is installed clean the screw thoroughly and lightly coat with grease applied with a paintbrush.
PAGE 4
POWER JACKS LTD DOCUMENT Spiracon Tel: +44 (0) 1358 285100 ISSUE No 1.4 email: sales@powerjacks.com PAGE 4 of 4 http://www.powerjacks.com _________________________________________________________________________________ 6.1 Brush Type Wiper The brush type wiper is retained in a recess at each end of the nut and is removed by releasing the retaining circlip, with standard circlip pliers, and removing / replacing the brush wiper. There is no specific orientation of the brush wiper. 6.