Engine Service Manual

34
Governor System
KohlerEngines.com 17 690 01 Rev. J
Electronic Governor Troubleshooting Flow Chart Continued
J1
J2
B1
K10
HI-1
HI-2
AB
C
D
H
GF E
Basic Wiring Harness Assembly Diagram
Inspect wiring harness for any broken or bad connections.
Terminal K10 and B1 are located in J1, Pin H (shown below).
Disconnect K10 and B1 terminals on wiring harness and retest.
Repair/Replace as necessary.
Does engine remain running?
YES
NO
YES
NO
Replace electronic
governor control and
retest.
Test control system of equipment.
Refer to Equipment Manufacturer’s
diagnostic procedures for control
system.
Engine starts but does not keep running.
Start engine in normal manner
as described in Owner’s
Manual.
OK?
NO
END
Test control system of
equipment. Refer to
Equipment Manufacturer’s
diagnostic procedures for
control system.
YES