Use and Care Manual

QVTOOLS, LLC | 2731 CRIMSON CANYON DRIVE, LAS VEGAS, NV 89128
POWERKING 1-800-344-3371 [e-mail]
Cutting The Full Stump
1. Make sure the throttle is set to fast. The cutter wheel will accelerate to cutting
speed.
2. Direct the cutter wheel against the stump, beginning with the nearest top
corner of the stump. Steadily sweep it across the stump left and right, cutting
away a ½ inch of wood with each sweep.
3. Raise and lower the cutter wheel between sweeps by lowering and raising the
control handle.
4. Roll the machine forward and back by pushing and pulling on the control
handle. To do this, release the brake. Relock it when the machine has been
repositioned and continue cutting.
Continue with the final removal of roots
Cut the remaining roots as described in step 2 until satisfactorily removed.
Shutting Off The Grinder
1. When stopping the machine after normal operation, lower the engine speed to
slow and press the emergency switch.
2. Set park brake before leaving the controls.
3. Shut off the engine by pressing the on/off switch.
Standard Shutdown Procedure
In consideration of your own safety and that of other, you should always use the
following normal shutdown procedures before departing from the controls for any