Full Product Manual

Take some protective measures before starting the machine.

It is necessary to have an empty running test to make sure linking parts are firm

enough, and check the amount of oil and fuel before operation. Turn on the motor to

have an empty running test. (Detail information please find in the motor manual

instruction.) After testing, it can be had a test with load from slight to heavy. Do not

operate machine with overload, the raw material put the feeding hopper should be

too big .it is determined by motor load. If it is overload, immediately reduce or stop

to draw the materials in. After a period of regular movement, putting into production

under no unusual noise or overheat phenomenon.

Keep the minors away from the spot.

Do not put hands or other body parts into hopper.

Do not get close to discharge port, the chips are expelled from discharge port can

hurt you or may cause serious injury.

If the machine makes abnormal vibration or unusual noises, immediately turn the

machine off and check it.

If there are many uncut materials, blades may be needed to sharpen or intervals

are needed to make adjustment. It is easy to cause injury due to blades are sharp

enough. Sharpen or adjust blades should go to indicate maintenance point. The

recommendation of blade intervals is 1-2mm.

Choice of chipping material: the fresh cut trees branches and straws can be

chipped directly. Due to different hardness and moisture content, the engine may stop

midway or the machine body may shake during the working, that’s normal.

Our recommend max. chipping capacity point to the annual plant, such as trees,

and straws. If chipping the perennial plant, you should shorten the chipping

diameter and lessen the material to feeding hopper . The ideal chipping for this

machine is suitable for fresh cut with 80% moisture content plant. During the

chipping process, you should obey the rule: Big side first, small side later, the trunk

first, the branch later. In order to get good chipping, it’s better put branches and

leaves together with the the bulk or segment of big trees. Block and short materials

are not allowed to be chipped separately, for the safety of the operator and the good

of the blades, they are better to be crushed with branches or straw.

Ⅵ

. Maintenance instructions

This

series of machine is only the main shaft bearing, which is needed to infuse

lubricating oil. After a period of using, it is necessary to infuse the grease. How ofter

to infuse grease is determined by using environment and it’s frequency. You must