Owner's Manual

8
POWERKING 1-800-344-3371 [e-mail]
The blades can be removed by using the included T-bar wrench or a 17mm Socket with
extension and ratchet driver. Make sure to use scrap wood or any soft material in the
drum to prevent it from moving. If the drum moves, you may strip the bolts. Also, use
rags or paper towel in the entry to prevent bolts or blades from falling into the drum.
Bar Blade
The bar blade is located at the bottom of the drum housing towards the entry chute. It
creates a gap for the chipping blades and creates a scissor action. If you have poor
chipping performance, we recommend adjusting this by loosening the bolts underneath,
adjusting the bar blade to about 1-5mm to the chipping blades, make sure it is parallel
to the chipping blades and retighten.
Jams
Stop the machine, remove both entry chute and exit chute. Remove the cap on the
bearing and turn the shaft using the included wrench. You can also use a larger
adjustable wrench if more force is needed. Try rotating in both directions to loosen
jammed material.
Easy Open Chutes
The machine features a latch mechanism for easy opening of the chutes. This provides
faster and toolless access to the drum area for clearing out debris or blade changing.