Troubleshooting Guide


Ē
Ē
. Troubleshooting
The common faults Elimination method
1 The engine cannot be started
Read the engine users’ manual, check the fuel
ON-OFF, see if it’s ON, check if gets enough
fuel and lubrication oil, check the
emergency stop button.
2 Engine flameout midway
Check if the engine is stopped by overloading,
check if something blocked in the chipping
hopper, check the emergency stop button and
protection switch.
3 The hopper blocked
Stop the machine, and remove the hoppers
and the cap of bearing, turn the shaft of roller
by the right spanner in the toolkit to clear the
blocked material. Don’t touch the blade
during the working, make sure your hands not
to be cut by the blades.
4 Has strange noise
Stop the machine, check if the fastener gets
loose, if not, let the professionals to check the
repair.
5 The blade destroyed
Go to the professional repair point to change
or repair the blades.
6 The belt damage Open the belt cover and change the belt.
7
The material grinding not
sufficient
Let the professional to adjust the blade
space, the recommended space for rough
chipping is 1.5mm-3mm, for fine chipping is
0.1mm-1.2mm.