Replacement Part List

17
When the support point is at one end
and the other end is free, the lower part
is pressed and the upper part is pulled.
In this case, cut approximately 1/3 of
the diameter upwards and then
downwards in the same position.
When both ends are supported, the
upper part is pressed, and the lower
part is pulled.
In this case, cut approximately 1/3
of the diameter downwards and then
upwards in the same position.
Wooden wedge Cut obliquely and one end can
smoothly fall down.
Warning
Ifthepulledorpressedpartoftimberisnotdetermined
correctlyandcuttingisstartedinthewrongdirection,
thechainontheguideplateofthechainsawwillbe
extrudedandcannotbemovedinthetimberseam.
Iftheengineisrotatingbutthechainisstuck,the
clutchofthechainsawwillbeburnt.
Ifthechainisstuckandthechainsawcannotbetaken
outofthechain,thesawmustnotbedraggedoutina
forcedmanner.Immediatelystoptheengine,insertthe
woodenwedgeintotheseamtoexpandtheseam,and
takeoutthechain.
Donotdragthechainsawifthechainisstuck.
Thebluntchainisnotsafeandthewearofthecutting
edgewillbeincreased.Agoodmethodtojudgethe
chainbluntnessistocheckwhetherthesawdustis
ne,insteadofnormalsawdust.
Warning
Afteroperationofthechainsaw,thehotcylinderhead
surfaceandmufercovermustnotbetouched.
Cut 1/3 of the
diameter upwards
Completion of
downward cutting
Completion of upward cutting
Cut 1/3 of the diameter
downwards