User Manual

Installation and Operator's Manual
(PVI-DESKTOP-yy-xx Rev: 1.2)
3 GETTING STARTED
WARNING: the PVI-DESKTOP requires some preliminary steps at the
initial start up of the system. Follow the instructions carefully for proper start
up.
3.1 FIRST RECHARGE OF THE BATTERY
The lithium battery inside the PVI-DESKTOP may not be completely charged, or even
completely discharged, at the time of initial start up. To avoid problems, it is
recommended that the object be charged for no more than 10 hours using the
appropriate power supply supplied. Charging is also possible via the USB port, even
when the object is completely turned off, but this takes slightly longer. The LED
indicating the charge will remain orange for the duration of the recharge turning green
once it is fully charged.
WARNING: Should recharging not be complete after 10 hours, unplug the
power supply, check that there is no overheating or deformation in the back
part of the object that would indicate potential damage to the internal battery.
NOTE: Charging via the USB port is slower than charging via external
power supply.
The PVI-DESKTOP can also be used with the power supply always connected.
Leaving the object always connected to the mains causes no problem to its operation
or to the battery. Nevertheless, it is recommended that a full charging and discharging
cycle of the battery be carried out every 2 months.
3.2 SELECTION OF INSTALLATION LOCATION
The PVI-DESKTOP can simply be placed on a flat surface or desk, or can be wall
mounted. This is possible thanks to the docking station with supporting feet and
preruptures for the fixing holes.