User's Manual

Release 0.4 – July 2017
V2P53 - WLAN board
V2P53 – WLAN board is a factory optionally
assembled communication board proper to be
used for instance on UNO-DM-PLUS inverter
series but not limited to this product family.
This communication board provides the fol-
lowing features:
- Wireless bidirectional communication 802.11
b/g/n compliant;
- Dual mode, access point + station;
- Data logging capabilities;
- 4GByte Flash disk storage;
- Integrated web server
It is a plugable board directly connected to
UNO-DM-PLUS logic board through a dedi-
cated connector.
Its installation on inverter is typically done by
factory, but when installed as a spare part in a
repairing process, the installation has to be
executed by trained personnel only.
The board is powered by the inverter.
Proper connector for antenna is available on
board.
The board uses a Murata LBWA17DZX6, an
802.11b/g/n WLAN module built around the
Cypress chipset.
Techical data are in following table.
In the block diagram are shown in/out buses
and signals.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including in-
terference that may cause undesired opera-
tion.
Any changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user’s authority to operate
the equipment.
Installer should take care that Regulatory La-
bel applied on the Host Equipment includes
the following: Contains FCC ID: X6W-V2P53.
Other labelling means as long as it includes
the text “Contains FCC ID: V2P53” is allowed.
This device shall be used such that a mini-
mum separation distance of 20cm/7,87” is
maintained between the radiator (antenna)
and user's/nearby people's body.
MODEL: V2P53
FCC ID
: X6W-
V2P53