User Manual

06
The MOVE emits electromagnetic energy
when in operation. Nearby electronic
equipment may thus be eected
by this emission. Similarly the MOVE may
itself be aected by electromagnetic
emissions from other equipment in the
vicinity.
The MOVE is intended for use in the
electromagnetic environment as specied
below. The customer or user of the MOVE
should assure that it is used in such an
environment:
– Floors should be wood, concrete or
ceramic tile. If the oor is covered with
synthetic material, the relative humidity
in the room should be at least 30%.
– Electric power quality should be that
of a typical domestic, or commercial
environment as appropriate.
– The MOVE should not be used during
power interruptions.
– Power frequency magnetic elds should
be at levels characteristic of a typical
location in a typical commercial or
domestic environment.
The MOVE is intended for use in an
electronic environment in which radiated
radio-frequency (RF) disturbances are
controlled.
The user of the MOVE can help prevent
electromagnetic interference by
maintaining a minimum distance between
portable and mobile RF communications
equipment (transmitters) and the MOVE
as recommended below, according
to the maximum output power of the
communications equipment:
The adequate separation distance to
provide base immunity to RF disturbances
is 1.5 feet or 1.0 meters.
Retain this user manual for your
future reference.
Electromagnetic Compatibility (EMC)
Precautions
The MOVE is suitable for use in all
establishments, including domestic
establishments and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes.
Set Up and Handling
Set up and Handling Instructions
Danger: to reduce the risk of electrical shock,
always unplug Power Plate before cleaning
or servicing it.
Warning: to reduce the risk of electrical
shock, re, burns, or other injury, always
plug Power Plate into a properly-grounded
electrical outlet.
Warning: to ensure safe use of Power
Plate, it must be regularly examined for
damage and wear. The machine, however,
contains no user-serviceable parts. Thus,
with the exception of the maintenance tasks
described later in this manual, the owner/
user should always retain an authorized
Power Plate service professional to perform
maintenance and/or service on the machine.
The machine should be set up on a hard,
level surface in an area free of obstructions
within at least three feet of the vibration
platform.
The machine should not be used outdoors,
near a pool, or near any source of water
or extreme humidity. Contact with water
could cause a short-circuit, which could
cause personal injury or damage to the
machine. Unplug the machine when not in
use.
Never attempt to lift or move the machine in
an unsafe manner.