INSTALLATION PS-200 Owner's manual

Apply a generous bead of a drain sealant around the lip of the drain body.

The drains with built-in valves will be oriented with the handle connection

toward the front of the sink. From inside the sink, insert the drain through

the drain hole and seat the flange against the sheet metal surface of the

tank. Be sure that the sealant compresses to where the rim of the drain

actually touches the sheet metal surface of the sink. If the drain does not

touch the sink it will work loose and leak as the sealant compresses over

time.

From the outside of the tank place the rubber vibration ring over the

threaded body of the drain followed by the Teflon ring and then the drain

nut. Tighten the nut “hand tight” until the handle is installed.

DRAIN BODY

APPROVED

DRAIN

SEALANT

RUBBER VIBRATION RING

TEFLON RING

FLANGE NUT

HANDLE CONNECTION

ORIENTED TOWARD THE

FRONT OF THE MACHINE.

BOTTOM OF SINK (Sink is laying

on its back side in this illustration)

THE RIM OF THE DRAIN MUST

SEAT ON THE SURFACE OF THE

SINK OR IT WILL WORK LOOSE

OVER TIME AND ALLOW WATER

TO LEAK AROUND THE DRAIN

IMPORTANT