INSTALLATION PS-225 Instruction Manual

3
Removal of Existing Unit
If the new Power Soak is not replacing an existing sink, skip this section. If
the removal of an existing sink is necessary, continue with this section.
Existing Supply Lines
The water and electrical source must be shut off before disconnecting or
cutting the water or electric lines.
Disconnect any electrical cord that is connected to the existing sink. Cut
the cold and hot water lines as closely as possible to the fittings on the
existing sink.
Existing Sink Removal
Detach any fasteners holding the existing sink in place and remove the
existing sink along with any shelves that may interfere with the installation
of the Power Soak. Discard all unwanted materials in an appropriate
container or disposal area.
Wall Preparation
Clean the wall(s) where the new Power Soak will be installed. Fill all
existing holes with an appropriate filler material. Be sure that any outlet
that will be covered by the sink has been disconnected and a water tight
cover has been installed over the opening.
Failure to shut off the electrical and water supply will result in personal injury,
including serious injury or death, and extensive equipment damage.
WARNING
Be sure to leave enough of the existing piping for the installation of new shutoff
valves. See “Pre-Plumbing” section for reference.
IMPORTANT