User Manual

(For PS1002, PS1003, PS1004, & PS1005)

1. The remote is designed to be mounted on a dash or

other flat surface.

2. The remote cable should be plugged into inverter and

the remote before being mounted. NOTE: The remote

is optional and not required for inverter operation. The

main power switch will turn the power on/off.

The DC circuit from the battery to the inverter should be

equipped with a disconnect and over-current device. This

usually consists of a circuit breaker, a “fused-disconnect”, or a

separate fuse and DC disconnect. Do not confuse AC circuit

breakers with DC circuit breakers. They are not interchange-

able. The rating of the fuse or breaker must be matched to the

size of cables used in accordance with the applicable installa-

tion codes. The breaker or disconnect and fuse should be

located as close as possible to the battery, in the positive

cable. Applicable codes may be limited as to how far the

protection can be from the battery. The picture on the next

page is for your reference.

INSTALLATION OF REMOTE CONTROL BOX

HOW TO INSTALL THE DC CIRCUIT BREAKER (DC CIRCUIT

BREAKER IS NOT INCLUDED)