User manual

11
4. Charging devices from mini-g via USB out port 2A
• Turn the mini-g on by holding down the on/o button (4) for 3 seconds.
• Select the micro USB to USB cable (8) or your devices’ own USB sync/charging cable.
• The mini-g will stop charging once the device is fully charged.
5. Permanent USB on mode (‘88’ setting)
• This feature is used if the USB device draws only a small amount of power.
• Disconnect all cables from the USB and DC out sockets.
• Turn the mini-g on by holding down the on/o button (4) for 3 seconds.
• Tap on/o button (4) until the ‘88’ function is shown on the LCD screen (5).
• The backlight will remain on while this feature is enabled.
• You may now connect your device to either of the USB ports (2).
• While this feature is in use, the DC out will output at 12V.
• You can simply press the on/o button (4) again to disable this feature.
6. Permanent DC on mode
• This feature is used if the DC device draws only a small amount of power.
• Turn the mini-g on by holding down the on/o button (4) for 3 seconds.
• Select the correct DC voltage for your device by tapping the on/o button (4) until desired voltage is
shown.
• Press the on/o button (4) twice in quick succession.
• The LCD screen will illuminate and on until the mini-g is manually turned o.