User manual
10
USING THE POWERGORILLA
This user guide covers both the powergorilla and the powergorilla tactical as they are identical in functionality and power
capability. The dierences between the two are the colour of the unit and the colour of the LCD screen.
1. Turning on the powergorilla
• To turn on the powergorilla, hold down the on/o button (4) for 3 seconds. Repeat to turn the unit o.
2. Recharging the powergorilla
• Recharge powergorilla via the universal AC mains charger supplied (6) with the appropriate plug head
into an electrical wall socket. Connect the DC end of the cable into the DC in port (1) of powergorilla.
• The LCD screen (5) will illuminate and the vertical bars will increase as it is being charged.
• When the sixth vertical bar is no longer ashing, this means the powergorilla is fully charged.
• Always disconnect the AC mains charger (6) when the powergorilla is fully charged or not in use.
NOTE: Please only use the AC mains charger provided to charge the powergorilla or ocial Powertraveller in-car charger
(available separately) Using a 3rd party AC mains charger may invalidate your warranty.
3. Charging devices via DC out port
• When connecting a device to the powergorilla, e.g. a laptop, please check the laptop’s input voltage.
This can be found on the laptop’s AC/mains adaptor or the user guide supplied with your laptop.
• Connect the DC cable (7) to the DC out port (3). Select the correct tip required from the tip pack (9).
• Select the required output voltage on the LCD screen (5). Do this by tapping the on/o button (4) until
the desired voltage is displayed on the LCD screen (5).
• When nished charging/powering, turn o powergorilla by holding down the on/o button (4) for
3 seconds and disconnect the cable. powergorilla will turn itself o when device connected is fully
charged.