Owner's Manual
6X9” SPEAKER INSTALL (OE692-TY, OE69C-TY)
1. After removing the door panel, unplug speaker plug
from factory speaker.
5. Fit speaker in place and make sure all mounting holes
line up. Install with the 4 supplied rivets (see fig 5. pg 4)
using a rivet gun, or the 4 x 10mm bolts you removed from
the factory speaker.
3. Remove factory speaker.
2. To remove the factory speaker either drill out the 4
rivets or unscrew the 4 x 10mm bolts (do not discard these
bolts you will need them to install your new speaker).
6. Now plug the factory speaker plug into the new speak-
er. If the factory plug is not long enough try to remove
some of the tape on the wire to extend it or use the sup-
plied extension cable (see fig 4, pg 4). Reinstall door panel
afterwards.
.OWYOUREREADYTOINSTALLYOURNEWSPEAKER
8