Owner's Manual

6X9" SPEAKER INSTALL (OE692-FD, OE69C-FD)
1. After removing the door panel , unplug speaker plug
from factory speaker .
3. Remove factory speaker.
5. Fit speaker in place and make sure all mounting holes
line up . Install with the four 4 x 7mm screws you removed
from lhe factory speaker .
8
2. To remove the factory speaker unscrew the 4 x 7mm
screws (do not discard these screws you will need them to
Install your new speaker) .
4. Now you're ready to install your new speaker.
6. Now plug the factory speaker plug into the new speak -
er . If the factory plug Is not long enough try to remove
some of the tape on the wire to extend it or use the sup -
plied extension cable (see Fig 4, pg 4) . Reinstall door panel
afterwards .