Owner's Manual

1. After removing the door panel, unplug speaker plug

from factory speaker.

5. Now plug the factory speaker plug into the new speak-

er. If the factory plug is not long enough try to remove

some of the tape on the wire to extend it or use the sup-

plied extension cable (see ﬁg 4, pg 4). Reinstall door panel.

2EMOVEFACTORY SPEAKER.OWYOURE READY TO INSTALL

your new speaker.

2. To remove the factory speaker either drill out the 3

rivets or unscrew the 3 x 10mm bolts (do not discard these

bolts you will need them to install your new speaker)

4. Fit speaker in place and make sure all mounting holes

line up. Install with the 3 supplied rivets (see ﬁg 5, pg 4)

using a rivet gun, or the 3 x 10mm bolts you removed from

the factory speaker.

6.5” SPEAKER INSTALL (OE652-TY, OE65C-TY)