Owner's Manual

Table Of Contents

SET UP ADJUSTMENTS

Your PS-AWB enclosure uses several controls to provide sonic integration with virtually any vehicles unique

acoustic properties. Please read the following section carefully to familiarize yourself with the function of

each control.

The following adjustment sequence is recommended to properly tune your PS-AWB enclosure. By ﬁrst

adjusting the GAIN, the LPF, then the PHASE switch, followed by the BASS EQ (in this order) will give you the

best results.

Input GAIN Control

This control allows you to match the input level of the ampliﬁer to the output level of your head unit (Fig 6).

Matching the input can be accomplished in four simple steps:

1. Make sure the remote gain control is not plugged in until after the master gain control is set.

2. Set the GAIN control on the ampliﬁer to MIN (completely counter clock wise).

3. Turn on the head unit and adjust the volume to 2/3 maximum, and set the BASS and TREBLE on the radio

(source) to zero or ﬂat.

4. Turn the GAIN control clockwise until the sound just begins to distort, then back off slightly to cut distortion

and operate at optimum gain.

Remember, the GAIN control is not a volume control. Ignoring these four steps above may leave you with a

damaged woofer and/or damaged ampliﬁer.

LPF (Low Pass Filter) Crossover Adjustment

Since musical tastes vary, adjust the crossover by ear while listening to the music of your choice. Turn the

crossover LPF adjustment all the way down to 50Hz. Then slowly turn the knob up until desired sound is

achieved. Normal listening level should be right around 100Hz to 150Hz. Use common sense when adjusting

the crossover. When properly adjusted, the bass from the PS-AWB enclosure should blend in with the rest

of your speakers and not overpower the music. Be sure to set the tone controls of your radio (source unit) to

ﬂat while dialing in the crossover. (Fig 7)

Fig.6 GAIN Control

GAIN

MINMAX

Fig.7 Low Pass Control (LPF)

50Hz

LPF

200Hz