Owner's Manual

5
1) The amplifier heatsink end should be facing out.
2) Ideally there should be several inches clearance between the amplifier heatsink and the seat or surface it is
backed up to. Make sure the open port beside the woofer is not obstructed.
3) When all connections are made the final step should be to secure the enclosure using the mounting brackets
provided so it remains securely in place.
WARNING: Make sure where ever you choose to place the enclosure it’s a dry location on a solid surface. Take
care that none of the mounting screws will pierce any wiring harnesses, brake or fuel lines, the vehicles fuel tank,
spare tire or any other parts of the vehicle. Some or all of these may be located behind or under the mounting
surface.
CONNECTIONS TO AMPLIFIER FOR
BATT+, GND and REM
For maximum transfer of Voltage it is highly recommended
to attach insulated Ring and/or Spade terminals to wire
ends connecting to the amplifier for Power
Connections. These terminals (not supplied) should
be soldered or at the very least crimped to the
wire-make sure no wire strands stray outside
the terminal barrel.