Owner's Manual

PS-AWB AMPLIFER CONTROL PANEL LAYOUT
Fig.2
1. LOW INPUT (RCA) Jacks
These RCA style input jacks are for use with source units that have RCA line level inputs. A source unit with
a minimum output of 100mV is required for proper operation. However, this input can accept levels up to
6Vrms.
2. HIGH INPUT
Use the High Input 4-pin Molex style jack when connecting to the speaker leads directly from a factory radio
without the use of a low level convertor. Be sure to observe the correct speaker polarity. (Do not use if you
are using the LOW INPUT from the RCA jacks).
3. REMOTE LEVEL (RJ45 Jack)
This is the connector port for the PS-AWB Remote Level control. Now the amplifiers secondary gain circuit
can be adjusted from the driver’s seat.
4. AUTO TURN ON (HIGH LEVEL INPUT MODE ONLY)
In the 'ON' position, the Auto Turn-On circuit will sense an input signal and turn the internal amplifier on
without using a remote turn on lead.
7
0 0
4.}-----
0
g}--------0 ~ 0
FUSE GND REM BATT+
10,,---------< .......... ,
0