Owner's Manual

TROUBLESHOOTING TIPS
Problem Solution
Power BLUE LED not ON With a Volt OHM Meter (VOM) check:
•
+ 12 Volt power terminal (should read + 12 to + 16VDC
•
Remote turn-on terminal (should read + 12 to + 16VDC)
•
Ground Terminal
Power LED lights BLUE, no output
•
Check RCA connections
•
Substitute known good Source Unit
•
Check for signal on the RCA cable with VOM in AC
position
The RED LED is ON, no output and
1. Amp is VERY HOT
•
Thermal protection is engaged. Check for proper
impedance at speaker terminals. Also check for
adequate air flow around the amplifier.
2.
Amp shuts down ONLY when the
•
Voltage protection engaged.
Voltage to the amp is
vehicle is running not within the 10-16 voe operating range. Have the
battery/charging system inspected.
RED Clip LED is ON
•
Readjust your Gain or Bass EQ settings to where the
Clip indicator flashes during heavy bass notes.
•
If the Clip indicator is constantly on this means the
output of the amplifier is now distorted and needs to
be readjusted.
Alternator noise (varies with RPM)
•
Check for damaged RCA cable .
•
Check routing of RCA cable
•
Check Source Unit for good ground
•
Check amp gain setting, turn down if set too high
Product Disposal - Certain international, national and/or local laws
and/or regulations may apply regarding the disposal of this product. For
further detailed information, please contact the retailer where you pur-
chased this product or the PowerBass Importer/Distributor in your country.
This manual is the exclusive property of PowerBass USA, Inc. Any reproduction of this manual, or use other than its intentions is strictly
prohibited without the express consent of PowerBass USA, Inc.
Copyright 2017 PowerBass USA, Inc.
16