Owner's Manual

Table Of Contents

Note: Remove any paint

below ring connector

Star Washer

Ring ConnectorBolt

Ground Wire

AUX INPUT

Connect the external audio input wire to your soundbar. Turn the soundbar on by holding the power button

for 3-5 seconds, an audible beep will conﬁrm that the soundbar is powered on. Now you can use the main

controller on the soundbar to adjust volume up, down and mute. Track back and forward as well as pause

will not work in AUX mode; these features work only in Bluetooth mode. In Aux mode these features can only

be operated by your connected device. (Radio, Phone or MP3 Player).

AUX OUTPUT

The soundbar will send up to 2 volts of audio output to either an external ampliﬁer (subwoofer or full-range)

or second soundbar. This is a variable output that is controlled by the main soundbar. Connect the 3.5mm

output to the audio input RCA or AUX input of your external ampliﬁer. If using a second soundbar use a

3.5mm to 3.5mm extension cable and connect the Aux output from the main soundbar to the Aux input of

the second soundbar. For distortion free sound, turn the volume all the way up on the second soundbar and

then back down two-three clicks.

Fig.4 Recommended Ground

Connection for Car & Trucks

Fig.5 Recommended Ground

Connection for UTV’s, RV’s,

Motorcycles and Boats