Application Guide

INSTALLATION EXPERIENCE

Installation of PowerBass mobile ampliﬁed soundbars requires detailed knowledge of electronics wiring. We

strongly recommend installation by an authorized PowerBass dealer. This Owner’s Manual only provides

general installation and operation instructions. If you have any reservations about your installation skills,

please contact your local PowerBass dealer for assistance.

IMPORTANT: This ampliﬁed soundbar is designed for operation in vehicles with 12-volt Negative

ground electrical systems only.

GENERAL INSTALLATION TIPS

Your PowerBass XL Bluetooth Soundbars were specially designed for providing high-ﬁdelity sound in any

terrain while being able to withstand the harshest of environments with their splash proof design and military

grade aluminum chassis. Possible damage to your speakers may occur if improperly used by overdriving the

system causing the sound to distort causing permanent damage to the speakers. Playing loud music in a

outdoor environment can permanently damage your hearing, as well as limit your ability to hear other trafﬁc.

1. Be sure to carefully read and understand the instructions before attempting to install this product.

2. Turn off the audio system. For safety, disconnect the negative lead from the battery prior to beginning

installation.

3. For easier installation, we recommend that if additional wiring is required, you run all wires prior to

mounting your soundbar in place.

4. The outdoor environment can quickly accelerate corrosion so always use the highest quality connectors

for a reliable installation and minimal signal or power loss.

5. Always use caution before you drill or cut! Be careful not to puncture gas tanks, fuel lines, hydraulic

lines or electrical wiring when working on any vessel or vehicle.

6. Never run soundbar wires underneath the vehicle or exposed on a boat deck, keeping the wiring

behind cover provides the best protection from environmental elements.

7. Avoid running any soundbar wire or signal cables near the vehicle’s electrical system to prevent noise

from “bleeding” into the audio system.

8. Leave a little slack in the soundbar wire for easier installation, this will prevent pulling or stretching the

wire and possibly causing a connection to come loose.