User manual PowerBus Leads 1.5mm 90cm
10 PowerBox-Systems − World Leaders in RC Power Supply Systems
This is the procedure:
b1) Do not connect the adapter to the PowerBUS lead at this stage.
b2) Connect the PowerBUS lead to the PowerBox.
b3) Press the SET button on the adapter while you plug in the PowerBUS lead.
b4) The red LED lights up at servo 1, then moves step-by-step to servo 4 while you
hold the button pressed in.
b5) Release the button when the red light is aligned with the servo output which
you want to set up. The red LED now shines less strongly.
b6) To program the output: Briey press the button the same number of times as
the channel which you wish to set up. Tor example, press the button ve times
in sequence for channel 5.
b7) When you have nished programming one output, save the setting simply by
disconnecting the adapter from the PowerBUS lead. Resume at Point b2) to
assign a further output.
Back to our example with two ailerons:
Hold the SET button pressed in while you connect the bus adapter, then immedia-
tely release it again. Servo output 1 at the adapter is required to generate PowerBox
output G: press the SET button twice in order to assign bus channel 2 to servo
output 1. Now disconnect the bus adapter again.