User manual PowerBus Leads 1.5mm 90cm

www.powerbox-systems.com 11
Hold the SET button pressed in once more while you connect the bus adapter, but
this time wait until the LED moves on to servo output 2. Servo output 2 at the adap-
ter is required to generate PowerBox output H: press the SET button three times in
order to assign bus channel 3 to servo output 2. Disconnect the bus adapter again.
Now connect the bus adapter and the two servos (outputs 1 and 2), and move the
aileron stick at the transmitter: the two servos should operate in parallel.
At this point you should call up the ServoMatch function at the PowerBox to ensure
that the two aileron servos do not work against each other mechanically.
First select output H, and ne-tune the servo which is connected to servo output
2 at the PowerBUS adapter to match the movement of the rst servo. Refer to the
instructions supplied with the Royal / Champion SRS for a detailed description of
this procedure.