User manual PowerBus Leads 1.5mm 90cm

6 PowerBox-Systems − World Leaders in RC Power Supply Systems
b) PowerBUS to BUS Adapter
The PowerBox to BUS Adapter is designed for use with servos which are tted
with an integral bus decoder. At present these are Futaba S-Bus servos. When the-
se servos are used, the channel assignment is programmed directly at the servo.
The PowerBox to BUS Adapter does not feature a decoder, but nevertheless all the
outputs are protected against short-circuits both in the signal wire and the power
supply wires, as you would expect. The adapter includes integral signal ampliers
for all servo outputs as weil as the adapter's PowerBUS output. This means that as
many bus adapters as required can be connected in series, i.e. cascaded.
c) PowerBUS to PWM Adapter
The PowerBox to PWM Adapter is used for servos which are not lled with a bus
decoder. In this case the channel assignment is dened at the PowerBUS to BUS
Adapter. The bus signal is decoded in the adapter, which then generates conventi-
onal PWM signals for the servos. This unit allows all known makes of servo to be
operated with the PowerBUS system. As with the other adapters, all the outputs
are protected against short-circuits both in the signal wire and the power supply
wires. The adapter includes integral signal ampliers for all servo outputs as well
as the adapter's PowerBUS output. This means that as many bus adapters as re-
quired can be connected in series, i.e. cascaded.