User Manual

34
PowerBox-Systems − World Leaders in RC Power Supply Systems
As you can see in the above illustrations, as standard the sequencer simply runs from the Start point at -20% to the Stop point at
+20%. To insert an additional point, press on the graph, then on Addition.
As you can see in the picture above right, an additional travel point has been added in the Servo 10-Forward sequence. You
can now select the point you wish to alter using the arrow buttons after Select point.
• Each point can be adjusted in terms of position and time - with the exception of the point at time 0.
• If you increase the time at the last point, the scaling of the time axis also changes accordingly.
• If you adjust the position of the first or last point, the End position in the opposite direction of operation is automa-
tically adjusted to suit!
• When you select a point, the associated servo moves slowly to the selected position. As soon as you operate the
sequencer switch, the marker is removed and the sequence commences. This enables you to check the sequen-
ce at any time.
NOTE
In the example shown here, Servo 10 remains motionless for three seconds after the switch is moved. After three seconds it
moves slowly - over three seconds - from +100% to -100%.
When reversed, the servo moves immediately from -100% to +100%, then remains motionless again for a period of six seconds.
In this example the door would stay still for one second, then
run from -100% to +100% over a period of one second. After
a two-second pause, the door would run from +100% to
-100%, again with a one-second delay. After a further second
the sequence is complete.
The reverse travel is identical to the forward travel.