User Manual

www.powerbox-systems.com

4.2.4. Auto Reset

If Auto Reset is set to On, then the timer will be reset to the starting time when the model is loaded, or when the transmitter is

re-started. If Auto Reset is set to Off, the timer value at the time the transmitter is switched off is stored by the transmitter in the

associated model ﬁle. This feature can be useful, for example, if you wish to use a single ﬂight battery for more than one ﬂight.

4.2.5. Audio Settings

In Version 2.80 the adjustment facilities for audio output have been signiﬁcantly enlarged, and incorporated centrally in the Timer

menu. For each timer one can use up to six audio or vibration alarms at various times or in various time ranges.

Brieﬂy press Audio settings at the bottom of the screen. In the display which then appears press + to set up a new audio out-

put.

Select the button under Time/Range in order to set the time range

and the type of alarm. You will then see the following display:

• Signal Start

Here you enter the Start time, i.e. the point from which the audio output is to commence. In the case of a count-down timer the

Start time must always be greater than the Stop time.

• Signal End

Here you enter the stop time for audio output.

• Repeat

At this point you can select the interval at which the audio output is to be repeated. You will then hear the audio output in the time

window which you entered at Start/Stop time.

If you only want the audio output to occur once, brieﬂy press the Interval button to switch it to Once.

• Signal Typ

Here you can select the Signal Type: various outputs can be combined, such as Beep and Vibration.

If you want to use the output for Text, Speech and Short Speech, hold the button pressed in order to select an individual text

or voice.