User Manual

PowerBox-Systems − World Leaders in RC Power Supply Systems

• Language

The Language setting affects the output of speech and telemetry data. When the sensors are scanned, the selected language

is sent to the sensor, which then sends back the telemetry values using the terminology in that language - if implemented.

• Units

It is also important to set your preferred units of measurement: the system sends your choice of Metric or Imperial to the tele-

metry sensors, and the sensors then deliver all telemetry values using your preferred units, such as kilometers / miles or liters /

gallons.

• Software

The Software menu will be discussed later; the transmitter and receivers can be updated at this point.

• Servo/Data

The Servo / Data setting determines whether the 3-pin output under the cover generates a PWM servo signal to act as a servo

tester, or a real-time telemetry output in the P²BUS format. The latter makes the telemetry data from the model accessible at the

transmitter itself for further processing. Typical uses of this would be for recording devices or variometers with expanded functi-

ons used for Triangle competitions.

Since Version 2.35 this socket has acted as S.BUS or SRXL input for the Teacher / Student system. These two protocols can

be generated by the receivers used by virtually all radio control systems. This allows the Atom’s Teacher / Student system to be

very ﬂexible in operation, even in conjunction with low-cost Student transmitters made by a variety of manufacturers.

• FastStart

This feature stores the currently loaded model settings in the real-time computer when the transmitter is switched off. Next time

you switch on, you immediately have control of the model. The Linux computer boots in the usual way. Settings and trims are

only available once the Linux computer is running. This feature is extremely practical for competition work, or if you simply want

to extend or retract the undercarriage when rigging or dismantling the model.

• Telemetrie Logger

This button activates or disables the recording of telemetry data on the SD card. The default setting for this feature is ON.

• Calibration

Another important point is the Calibration menu; this is described in full at a later stage.

• System Informations

This button exports the system informations to an external memory stick.

3.1.2. Screen

Background,Color, Icons, Brightness

You can select your preferred color scheme here. The bright-

ness control should be set to a value which enables you to see

the screen content clearly and distinctly. Please note that the

screen brightness does have a perceptible effect on battery

duration!

• Dimmer

The Dimmer time setting determines the point at which the

screen is automatically darkened.

• Automatic lock

The automatic screen lock can be released again using the

- button.