manual

POWER BOX Evolution 40/16
- 15 -
Please don’t just throw away the inner packaging, as it includes a template for
marking the switch aperture. Cut or saw clear of the marked line, as shown in the
photo.
Even though our product is very well protected >from the effects of vibration, the
switch should always be mounted in a part of the model relatively low in vibration.
Please note that the GRP fuselage sides of a large power model are not suitable,
as they are always subject to considerable vibration. You can remedy the situation
by cutting a ply plate (2 - 3 mm thick) about 3 cm larger than the switch aperture,
and gluing it in the appropriate place, as shown in the photo. The plate absorbs
much of the vibration, and at the same time provides plenty of “meat” for the switch
retaining screws to bite into.
The SensorSwitch is available in the colours black or grey, and one or other
version is very likely to blend inconspicuously with the colour scheme of your
model.