User Guide

IMPORTANT SAFETY INFORMATION.
READ ALL SAFETY WARNINGS BEFORE OPERATION!
FAILURE TO OBEY THESE WARNINGS MAY RESULT IN LOSS OF LOAD, DAMAGE TO JACK,
AND OR JACK FAILURE RESULTING IN PERSONAL INJURY OR PROPERTY DAMAGE.
AUTO/MOTORCYCLE/ATV JACK
• STUDY, UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THIS DEVICE.
• DO NOT EXCEED RATED CAPACITY.
• USE ONLY ON HARD LEVEL SURFACE.
• LIFT ONLY ON AREAS OF THE VEHICLE AS SPECIFIED BY THE VEHICLE MANUFACTURER.
• NEVER GET BENEATH THE VEHICLE BEFORE THE SAFETY PIN IS INSERTED IN THE JACK.
• IF VEHICLE IS PUSHED OFF OF JACK, DISCARD JACK. DO NOT REUSE.
• PLACE LOAD IN CENTER OF SADDLE ONLY. LOAD SADDLES EQUALLY TO PREVENT TIPPING.
• USE HOLD DOWN STRAPS TO SECURE LOAD TO THE JACK .
(USE STRAPS WITH 150% RATED CAPACITY OF LOAD: STRAPS NOT INCLUDED)
• USE THE SAFETY LOCK BAR WHEN LOAD IS RAISED TO PREVENT ACCIDENTAL LOWERING.
• DO NOT MOVE OR DOLLY THE VEHICLE WHILE ON THE JACK.
• KEEP CHILDREN AWAY FROM WORK AREA.
• ONLY ATTACHMENTS AND/OR ADAPTERS SUPPLIED BY THE MANUFACTURER SHALL BE USED.
• NO ALTERATION SHALLBE MADE TO THIS PRODUCT.
• FAILURE TO HEED THESE WARNINGS MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE.
ASSEMBLY
• Slide the lower handle into the upper handle, depress the locking
button, and slide into the bottom section until button snaps
into hole. (Fig.A)
• Loosen the handle socket screw in the yoke.
• Apply a small amount of grease to the handle socket.
• Place the assembled handle into the handle socket. (Fig. B)
• Tighten the handle socket screw.
INSPECTION
The product shall be maintained in accordance with the product instructions. No alterations shall be made to this product.
1. Before each use, a visual inspection of the jack shall be made for abnormal conditions such as cracked welds, damaged,
bent, worn, loose or missing parts, or hydraulic leaks.
2. Inspections shall be performed in accordance with this manual.
3. The product shall be inspected immediately if the jack is believed to have been subjected to an abnormal load or shock. It
is recommended that this inspection be made by an authorized customer service representative prior to use.
4. Repair of this equipment requires specialized knowledge and facilities. If the jack is subjected to abnormal load or shock,
remove from service and have it examined by an authorized inspection repair facility. Any defective parts, decals, or safety
labels shall be replaced with manufacturer’s specified parts. If you encounter any problems or difficulties, please do not
return this jack to the store. Please contact our toll free customer service department at: 1-800-423-3598 for a list of
authorized inspection facilities.
5. Attachments and Adapters. Only attachments and/or adapters supplied by the manufacturer shall be used.
Socket Screw
Fig. A
Fig. B
4