Installation Guide
CR Family Hardware
Installation Guide
CR Family Hardware Installation Guide Page 12 of 38
Copyright © 2015 by Pointer Telocation, Ltd.
Please refer to Cellocator Fuse Harness Overview for installation instructions for the Fuse
Harnesses. ---------------------------------------------------------------------------------------
----
IMPORTANT:
• The CR unit must be protected by means of a 3A fast blow fuse. The fuse should
be installed either between Power Input (Pin 1) and the vehicle protected power
line.
• The CR unit must be protected by means of PTC for safety certification
compliance. The PTC should support Resettable Fuse 60V and Imax=40A. It
should be installed between Power Input (Pin 1) and the vehicle protected power
line.
• These means of protections are supported by the by the fuse attached to the
harnesses provided by Cellocator.
• It is the installer responsibility to provide these means of protection if the fuse
provided by Cellocator is not used.
-------------------------------------------------------------------------------------------