Product Manual
24
REPLACEMENT & INSTALLATION OF THE BATTERY
Use only batteries meeting the following criteria:
a. Battery type: Sealed lead-acid, AGM.
b. Nominal voltage: 12 VDC.
c. Capacity: 60 Ah or 80 Ah or 90 Ah or 100 Ah.
d. Battery should comply with UL1989 standard.
e. When installing the battery, make sure the polarity connections are correct.
NOTICE: Battery has to be recharged immediately once purchased. All
rechargeable batteries gradually discharge when left standing. Periodic charging
is necessary to maintain maximum battery capacity.
WARNING: Study all battery manufacturers’ specic precautions and
warnings in advance before assembly. Incorrect connection may cause a short
circuit and personal injury. Follow all recommended guidelines. Refer to page 24
for more recommended information.
CAUTION: Risk of explosion if battery is replaced by an incorrect type.
Dispose of used battery properly. Do not dispose of battery in a re. The battery
may explode.
CAUTION: Servicing of battery should be performed only by a factory-
authorized service center. When replacing the battery, replace with the same
type of battery.
CAUTION: Do not open or mutilate battery. Released chemical is harmful to
the skin and eyes and is toxic.
CAUTION: A battery can present a risk of electrical shock.
The following precautions should be observed when working on battery:
1) Remove watches, rings, or other metal objects.
2) Use tools with insulated handles.
3) Wear rubber gloves and boots.
4) Do not lay tools or metal parts on top of battery.
5) Disconnect charging source prior to connecting or disconnecting battery
terminals.
6) Determine if battery is inadvertently grounded. If inadvertently grounded,
remove source from ground. Contact with any part of a grounded battery can
result in electrical shock. The likelihood of such shock can be reduced if such
grounds are removed during installation and maintenance.
What’s required for install?
• Phillips Screwdriver
• Small Slot Screwdriver
• Electrical Tape