Product Manual

Summary of Important Safety Information for Operation (cont’d)
38
Safety During Use
Safety equipment / controls. Always operate the generator with all safety covers, guards, and barriers in place and in
good working order, and all controls properly adjusted for safe operation.
Know how to stop. Be thoroughly familiar with proper use of the equipment and all generator controls, output
receptacles, and connections. Know how to stop the generator quickly if needed.
Damaged. DO NOT operate the generator with damaged, missing, or broken parts.
Carbon monoxide exhaust. The running engine gives off carbon monoxide, a poisonous gas that can kill you. You
CANNOT smell it, see it, or taste it. If you start to feel sick, dizzy, or weak while using the generator, shut off the engine
and get to fresh air RIGHT AWAY. See a doctor. You may have carbon monoxide poisoning.
Smoking/sparks. Never smoke near the running generator, and never operate near sources of sparks or flames.
Check output voltage. Check output voltage to ensure the generator is working properly before connecting loads to the
generator. Failure to do so could result in damage to equipment powered by the generator and possible injury to the
individual. DO NOT adjust output speed of engine to change voltage. If voltage is not within specified range, have
generator repaired by factory-authorized personnel.
Stabilize before connecting loads. Start generator and let engine stabilize before connecting electrical loads.
DO NOT overload. DO NOT overload the generator. Make sure that combined starting and running loads do not exceed
rated capacity of generator or damage will result.
Protect sensitive electronics. Some electronic equipment, such as computers and audio/video equipment, can be
damaged by small fluctuations in the flow of power. Use a surge suppressor for any voltage-sensitive electronic
equipment you will be powering with the generator.
Wet conditions. DO NOT operate the generator or handle any electrical equipment while standing in water, while
barefoot, while hands are wet or while in the rain or snow. Electric shock may result.
Ground fault circuit interrupter. Always use a ground fault circuit interrupter (GFCI) protected extension cord (or outlet,
if generator is equipped) in damp or highly electrical conductive areas and on construction jobsites to prevent electrical
shock.
Electrical cords. Use only UL-listed, outdoor-rated, three prong extension cords of the proper size. All extension and
appliance cords must be in good condition and not worn, bare, frayed, or otherwise damaged. Use of inadequate or
damaged electric cords can cause electric shock or fire.
Avoid contact. Avoid contact with bare wires, terminals, connections, etc. while the unit is running.
Electric shock accident. If an electric shock accident occurs, immediately shut down the source of electrical power. If
this is not possible, attempt to free the victim from the live conductor. Avoid direct contact with victim. Use a
nonconducting implement, such as a dry rope or board, to free the victim from the live conductor. Apply first aid and get
immediate medical help.
Hot muffler. Never touch hot muffler, hot exhaust manifold, or engine cooling fins. Exhaust and engine parts can be very
hot and will burn you.
Moving parts. Keep hands, feet, and apparel away from drive belts, fans, and other moving parts. Never remove any
drive belt or fan guard while the unit is operating.
Refueling. DO NOT refuel the engine until it has cooled at least two minutes.
Malfunction during operation. Immediately turn off the generator if any of the following conditions arise during
operation:
o Excessive change in engine speed, slow or fast
o Overheating in load connecting devices
o Sparking or arcs from generator
o Loss of electrical output
o Receptacle damage
o Engine misfire
o Excessive vibration
o Flame or smoke
o Abnormal noise
Adjusting / repairing. Always turn off generator and remove spark plug(s) or spark plug wire(s) before working on the
generator to prevent accidental starting.