Product Manual

Assembly Instructions

Step 14 -Fittings

• Remove plug from cylinder port and discard

• Lubricate O-ring and threads on fitting with clean oil

• Orientate (1) Valve to Cylinder Fitting so that nut/washer/O-ring

assembly is facing up. Turn fitting into cylinder port until finger-tight

• Torque to 27-43 ft.-lb.

• Looking at fitting from end with nut/washer/O-ring assembly, turn nut

clockwise as far as possible

• Use valve port marked “A” to thread the control valve onto the fitting

until control valve touches washer

• Hold control valve in orientation shown below and torque nut to 37-46

ft.-lb.

Tools Needed

• 7/8” Wrench

(2 needed)

• Crescent Wrench

(2 needed)

• Torque Wrench

Fittings Needed from Parts Bag:

Valve Fitting

Cylinder Port

Valve Port

Part # 790488

Valve to Cylinder Fitting

Qty: 1

Nut

Washer

O-Ring

Into

Cylinder