Installation Instructions

PK0101
PG 6
I. RULES FOR SAFE OPERATION
WARNING CONTINUED:
CHECK FOR DAMANGED PARTS
Before using a power tool, check for damaged parts. A guard or any other part that is damaged should be carefully checked to
determine if it would operate properly and perform its intended function. Always check moving parts for proper alignment or
binding. Check for broken parts, mountings and all other conditions that may affect the operation of the power tool. A guard or
any damaged part should be properly repaired or replaced.
DIRECTION OF FEED
Always feed work into a blade or cutter against the direction of
rotation.
CUTTING BLADE SAFETY:
t6TFBQQSPQSJBUFTUFFMDFOUFSFEDVUUJOHCMBEFTNBOVGBDUVSFEGPSVTFPODPODSFUFDVUUFST
tALWAYS inspect cutters blades before each use. The blade should exhibit no cracks, dings or flaws in the steel centered
core and/or rim. Center (arbor) hole must be undamaged and true.
t&YBNJOFCMBEFGMBOHFTGPSEBNBHFFYDFTTJWFXFBSBOEDMFBOMJOFTTCFGPSFNPVOUJOHCMBEF#MBEFTIPVMEGJUTOVHMZPOUIF
shaft and against the inside/outside blade flanges.
tALWAYS keep blade guards in place.
t&OTVSFUIBUUIFDVUUFSCMBEFEPFTOPUDPNFJOUPDPOUBDUXJUIHSPVOEPSTVSGBDFEVSJOHUSBOTQPSUBUJPODO NOT drop the
cutting blade on ground or surface.
t5IFFOHJOFHPWFSOPSJTEFTJHOFEUPQFSNJUNBYJNVNTQFFEJOBOPMPBEDPOEJUJPO4QFFETUIBUFYDFFEUIJTMJNJUNBZDBVTF
the cutting blade to exceed the maximum safe allowable speed. DO NOT MODIFY THE ENGINE.
t&OTVSFUIBUUIFCMBEFJTNPVOUFEGPSQSPQFSPQFSBUJOHEJSFDUJPO