Replacement Part List

Graphic 13

5.8 Belt Replacement

See Graphic 14

The trowel is equipped with a self-adjusting clutch. This clutch automatically tightens the

belt and compensates for belt wear. Replace the belt if the clutch can no longer tighten belt

enough to engage gearbox without slipping.

To replace the drive belt:

5.8.1 Disconnect the spark plug lead.

WARNING: To avoid accidental starting of the engine, always disconnect the

spark plug lead before working on machine.

5.8.2 Loosen the screws (d) and remove the belt guard (c).

5.8.3 Slowly turn the pulley (b) and roll the belt (a) off.

Note: The clutch and the pulley are aligned at the factory and neither should be removed

during belt replacement.

5.8.4 Install the new belt.

5.8.5 Reattach the belt guard with washers and screws. Torque the screws to 5 Nm (3.7

ft·lbs.).