Manual

POWERMADD

1-800-435-6881

www.powermadd.com

PP5043 REV A

POWERMADD

Ski-Doo CargoCaddy

Installation Instructions for Part No. 13733

NOTE: This instruction sheet #PP5043 is for Ski-Doo snowmobiles that utilize the vented clutch guard in the MXZ

chassis. Older Ski-Doo snowmobiles without the vented clutch guard should use the universal instruction sheet #PP5011.

HARDWARE INLCUDED: TOOLS REQUIERED: OTHER AVAILABLE MODELS:

Qty

Description Power Drill Part No. Description

1 CargoCaddy 7/32 & Drill Bit 13730 Universal

3 Dividers Pop Rivet Gun 13731 Polaris Edge Chassis

5 Foam Top Pads Center Punch 13732 Arctic ZR Chassis, 2000 & Newer

1 Foam Bottom Scissors (wont fit ZR 800 or ZR 900)

2 Mounting Brackets Tape

8 3/16 Pop Rivets

1 Spare Belt Bracket (for universal mount only)

WARNING: Read all instruction prior to installation. Never work on a snowmobile while snowmobile is running.

Before any drilling is done to your snowmobile, take adequate precautions to be sure no debris will end up in your

clutches or any other areas that may cause damage or injury. If possible, remove the clutch guard from the

snowmobile before drilling any holes or doing any riveting, this will make installation cleaner and easier.

Step 1: Drill through the bottom of the CargoCaddy from inside at bosses #1,

#3, #4 and #6 with a 7/32 drill bit.

Step 2: Rivet the brackets to the bottom of the CargoCaddy as shown in the picture.

Step 3: Remove any previously installed spare spark plug or drive belt holders from the top of the clutch guard that

will interfere with the CargoCaddy.

Step 4: Carefully cut out the paper mounting template along the dotted line. NOTE: It will be easier to line up

with the clutch guard if the template is cut out accurately.

PAGE 1
POWERMADD® Ski-Doo CargoCaddyTM Installation Instructions for Part No. 13733 NOTE: This instruction sheet #PP5043 is for Ski-Doo snowmobiles that utilize the vented clutch guard in the MXZ chassis. Older Ski-Doo snowmobiles without the vented clutch guard should use the universal instruction sheet #PP5011.
PAGE 2
Step 5: Tape the paper template on top of the clutch guard, lining up the front edge of the template with the edge of the last vent. Make sure the longest edges of the template are parallel to the length of the clutch guard. Also use these edges to center the template on the clutch guard. Step 6: Place the CargoCaddy on the clutch guard with the clutch guard installed on the snowmobile. Line up the four holes in the brackets with the four marks on the template.
PAGE 3